| Here is the
configuring instruction (for Z5 and J5/Z7), follow EXACTLY !
Important: Your phone is NOT configured for data by default.
If you have not used the phone for data before, you must configure
it:
Settings>Call settings>Data services>Serial
speed>Automatic (press jog dial)
Automatic serial
speed is best for most applications, although almost all speed should work for
data. Configuring Clie : Go to System screen
and tap “Prefs”
Tap right top corner and select “Connection”
Tap “New”
Name:
Sony Z5 (or any other name you wish)
Connect to: Modem (or Serial to Modem)
Via: Cradle / Cable
Dialing: TouchTone
Volume: Low
Tap
“Details”
Speed : 115,200 bps
Flow Ctl : Automatic
Init String : AT&F&D2
Tap “OK” and “OK”
Tap right top corner and select “Network”
Service : xxxxxx (Your ISP, any name you wish)
User Name: xxxxxx (Your ISP log on user name)
Password : xxxxxx
Connection : Sony
Z5
Tap “details”
Connection Type : PPP
Idle timeout
: 3 minutes (or never)
Query DNS :
enter the Primary/Secondary DNS of your ISP, if needed.
IP Address : check Automatic
Tap “OK”
Tap
“phone” to enter Phone Setup screen
Phone # : enter your ISP number WITH A FULL STOP ( . ) BETWEEN EVERY
NUMBER !!
e.g. if your ISP
number is 0845-123456, enter 0.8.4.5.1.2.3.4.5.6
If your ISP number is 10 (or 12) digits or less you may have to add ONE
OR MORE COMMA (,)
before the phone number like this: , , 0.8.4.5.1.2.3.4.5.6
(Add one (,) at a time until the phone
can successfully dial out.)
Tap “OK”
Tap
“Connect” - the phone should display “Outgoing Data” and the ISP number
it is dialing
If the phone fails to
dial and display :"Error: phone number is too long or contains invalid
characters (0x1109)" , go back to
the phone setup and add a COMMA (,) in front of the number
and try again (and again) until the phone can successfully dial out.
(if your ISP number is short - like 4 digits – add 4 (, , , , ) COMMAs initially)
If the phone fails to dial and display: Error:
Modem not found (0x1106), disconnect all cables,
switch off phone and back on, then connect back all cables and try again.
If it still cannot dial
out, check every setting from the beginning, particularly for something that
should not be there
(script? init string? uncheck anything that should not be checked)
If you are successfully connected to your ISP, a “Disconnect”
tab appears at the bottom of Network screen.
Now you
can browse the web and check email (with suitable software, Eurdora is recommended
for email and Avantgo for internet, which are available for download free)
When you have finished your internet/email session, go back to
Prefs-Network screen and tap “Disconnect” (you may also have to terminate the
call manually on the phone) Other Tips:
Connect the cable to Clie first and then the phone end.
If you are planning on a long internet session make sure you
have plenty of power left in your Clie as the cable also draws power from the
Clie and there is no other way to recharge your Clie but to disconnect the cable. |
