All
credit card orders are processed by CCNow. Customers can be sure that all
information supplied are secured and will not
be used for any other purpose other than this sale transaction.
Please
note that credit card order (minimum order $11.50 excluding postage) can
only be sent to card holder at his/her registered address. We may not be
able to process credit card orders for card issued by some countries. In
that case or if you do not have a credit card, please see other
methods of payment.
Remove the back cover and battery, then remove
the antenna.
The internal antenna is secured with 2 notches on the sides and 2
hooks at the top. Use a tiny flat screwdriver or blade and lever between
the side of the antenna and the phone body (Be careful, we have reports that the
antenna may break). Do it on both sides to release the notches and the
antenna will be released towards the top.
After the antenna is removed,
use a T-6 screw
driver to remove the 4 screws. Then lift out the metal plate where
the vibra motor will be fitted.
Place the motor into the hollow and it should fit tightly.
Make sure that the vibra motor sits in the hollow
flat
and square and in the middle. Note the hole on the rubber, it hooks onto the
notch on the side of the metal plate
thus locking it in place loosely so that it does
not fall out when you turn it upside
down to fit it back to the phone.
You can now fit the metal plate back on to the
phone. The vibra motor should sit just
on top of the contact points. Reassemble the
phone and you are there.
